GODHAND Spin Blade 0.5mm-0.9mm
£44.99
Spin Blade 0.5mm-0.9mm - Set of 5
Ultra-fine size with a blade width of less than 1 mm that can easily process flat bottoms of round holes! It is attached to the pin vise body and used as a small carving knife to flatten the bottom of drill holes. Since the axis is unified to 3 mm, replacement of the collet chuck of the pin vise body is not required, making it easy to replace. Compatible with drill bit 5-piece set A. Excellent usability as a thin carving knife. Great for engraving details on figures and mini-mechas!
The size is 0.5mm ~ 0.9mm (5 piece set). A chisel with a thin blade of 0.5 mm, 0.6 mm, 0.7 mm, 0.8 mm, and 0.9 mm with a unified blade size for a 3 mm shaft size.
*Because it is a knife, please handle with care when opening the lid or using it.
Product Details
Product Code: GH-SB-05-09
Quantity: 5 pieces (1 piece per size)
Hole Bottom Diameter: 0.5mm/0.6mm/0.7mm/0.8mm/0.9mm
Shaft Thickness : 3.0mm
Material: Special blade steel
Case: PP
Size: Approx. 150mm x 150mm
Weight: 33g
Origin: Japan
Quantity
Only 3 left in stock
How to Use
・Attach the drill blade to the pin vise and dig a hole
・Attach a spin blade with the same diameter as the drilled hole to the pin vise.
・Scrub the bottom of the carved hole with a spin blade.
⚠NOTE
・Please fix the pin vise firmly in place before use.
・Please be sure no one is around and wear protective glasses.
Cutting materials or broken blades in the eyes may cause blindness.
・Blades made of hard metal, however, may damage or injure unexpectedly if excessive force is applied or improperly used.
・After use, wipe with a dry cloth, lubricate with oil, and place in the case.
・Please be careful to avoid injury
・Please do not apply a load exceeding the capacity.
・When spinning the Spin Blade, ensure to drill pilot holes with the same diameter before use.
