GODHAND Spin Blade 2.1-2.4mm
£19.99
Spin Blade 2.1-2.4mm - Set of 4
Flattening the bottom surface of a hole made with a drill blade of the same diameter (drilling edge processing) is possible. Installed on a pin vice body for flat processing of drill hole bottoms and use as a small chisel tool. The shaft is standardised to 3mm, eliminating the need to replace the collet chuck of pin vices, which results in easy replacement. Excellent for use as a thin-blade chisel tool.
A 4-piece set sizes from 2.1 mm to 2.4 mm.
*Please take extra caution when handling the blades, especially when opening the storage case or during use.
Product Details
Product Code: GH-SB-21-24
Quantity: 4 pieces (1 piece for each size)
Material: Special cutlery steel (with case)
Hole Diameter: 2.1 mm, 2.2 mm, 2.3 mm, 2.4 mm
Shaft Thickness: 3 mm
Case: PP
Size: Approx. 150mm x 150mm
Weight: 30g
Origin: Japan
Quantity
Only 3 left in stock
How to Use
1. Attach a drill blade to a pin vise to drill a hole.
2. Attach a spin blade with the same diameter as the drilled hole to the pin vise.
3. Flatten the bottom of the drilled hole with the spin blade.
⚠NOTE
・Please fix the pin vise firmly in place before use.
・Please be sure no one is around and wear protective glasses.
Cutting materials or broken blades in the eyes may cause blindness.
・Blades made of hard metal, however, may damage or injure unexpectedly if excessive force is applied or improperly used.
・After use, wipe with a dry cloth, lubricate with oil, and place in the case.
・Please be careful to avoid injury
・Please do not apply a load exceeding the capacity.
・When spinning the Spin Blade, ensure to drill pilot holes with the same diameter before use.
